收藏本站
PCA9626
24-bit Fm+ I 2 C-bus 100 mA 40 V LED driver
Rev. 3 — 6 September 2012
Product data sheet
1. General description
The PCA9626 is an I 2 C-bus controlled 24-bit LED driver optimized for voltage switch
dimming and blinking 100 mA Red/Green/Blue/Amber (RGBA) LEDs. Each LED output
has its own 8-bit resolution (256 steps) fixed frequency individual PWM controller that
operates at 97 kHz with a duty cycle that is adjustable from 0 % to 99.6 % to allow the
LED to be set to a specific brightness value. An additional 8-bit resolution (256 steps)
group PWM controller has both a fixed frequency of 190 Hz and an adjustable frequency
between 24 Hz to once every 10.73 seconds with a duty cycle that is adjustable from 0 %
to 99.6 % that is used to either dim or blink all LEDs with the same value.
Each LED output can be off, on (no PWM control), set at its individual PWM controller
value or at both individual and group PWM controller values. The PCA9626 operates with
a supply voltage range of 2.3 V to 5.5 V and the 100 mA open-drain outputs allow
voltages up to 40 V.
The PCA9626 is one of the first LED controller devices in a new Fast-mode Plus (Fm+)
family. Fm+ devices offer higher frequency (up to 1 MHz) and more densely populated
bus operation (up to 4000 pF).
The active LOW Output Enable input pin (OE) blinks all the LED outputs and can be used
to externally PWM the outputs, which is useful when multiple devices need to be dimmed
or blinked together without using software control.
Software programmable LED Group and three Sub Call I 2 C-bus addresses allow all or
defined groups of PCA9626 devices to respond to a common I 2 C-bus address, allowing
for example, all red LEDs to be turned on or off at the same time or marquee chasing
effect, thus minimizing I 2 C-bus commands. Seven hardware address pins allow up to
126 devices on the same bus.
The Software Reset (SWRST) Call allows the master to perform a reset of the PCA9626
through the I 2 C-bus, identical to the Power-On Reset (POR) that initializes the registers to
their default state causing the output NAND FETs to be OFF (LED off). This allows an
easy and quick way to reconfigure all device registers to the same condition.
In addition to these features found in PCA9633, PCA9634, PCA9635, PCA9622 and
PCA9624, a new feature to control LED output pattern is incorporated in the PCA9626. A
new control byte called ‘Chase Byte’ allows enabling or disabling of selective LED outputs
depending on the value of the Chase Byte. This feature greatly reduces the number of
bytes to be sent to the PCA9626 when repetitive patterns need to be displayed as in
creating a marquee chasing effect.
If the PCA9626 on-chip 100 mA NAND FETs do not provide enough current or voltage to
drive the LEDs, then the PCA9635 and the PCA9635 with larger current or higher voltage
external drivers can be used.
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
PCA9632DP2,118 IC LED DRIVER RGBA 10-TSSOP
PCA9633BS,118 IC LED DRIVER RGBA 16-HVQFN
PCA9634D,118 IC LED DRIVER RGBA 20-SOIC
PCA9635PW/S911,118 IC LED DRIVER RGBA 28-TSSOP
PCA9685PW,118 IC LED DRIVER RGBA 28-TSSOP
PCA9922PW,118 IC LED DRIVER LINEAR 16-TSSOP
PCA9955TW,118 IC LED DRVR CONST CURR
PCF85102C-2P/03,11 IC EEPROM 2KBIT 100KHZ 8DIP
相关代理商/技术参数
PCA9629APWJ 功能描述:Bipolar, Unipolar Motor Driver CMOS I2C 16-TSSOP 制造商:nxp semiconductors 系列:- 包装:剪切带（CT） 零件状态:有效 电机类型 - 步进:双极性，单极 电机类型 - AC，DC:- 功能:控制器 - 换向，方向管理 输出配置:前置驱动器 - 半桥（4） 接口:I2C 技术:CMOS 步进分辨率:1 ~ 1/128 应用:通用 电流 - 输出:- 电压 - 电源:4.5 V ~ 5.5 V 电压 - 负载:- 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商器件封装:16-TSSOP 标准包装:1
PCA9629PW,118 功能描述:马达/运动/点火控制器和驱动器 I2C-bus Stepper motor controller RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube
PCA9629PW118 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述:
PCA9632DP1,118 功能描述:LED照明驱动器 4-BIT FM+I2C-BUS RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9632DP1-T 功能描述:LED照明驱动器 4-BIT FM+I2C-BUS LOW POWER LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9632DP2 制造商:NXP Semiconductors 功能描述:IC LED DRIVER RGBA 10-TSSOP 制造商:NXP Semiconductors 功能描述:IC, LED DRIVER, RGBA, 10-TSSOP
PCA9632DP2,118 功能描述:LED照明驱动器 4-BIT FM+I2C-BUS RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9632DP2118 制造商:NXP Semiconductors 功能描述:IC LED DRVR TSSOP